Bradley 2902-280000 Manuel D'installation Et D'utilisation page 15

www.bradleycorp.com
5. Installing the cover on the hand dryer taking care to insert the
upper tab in its housing in the base-plate (see figure nº 9).
6. Unscrew the screws in a counter-clockwise direction (CCW)
using the supplied special tool (see figure 10).
7. Place the hands inside the detection area of the appliance in
order to assure the right performance of the hand dryer.
Care must be taken during this operation not to touch the electronic circuit that
is housed under the volute.
NOTE: a minimum distance of 40 cm (15.8") must be allowed between any
possible shelves, marble or washbasins (see figure 11). As far as possible,
reflecting surfaces should be avoided within the operating range of the IR
sensors.
MACHINE MUST BE HANDLED ONLY BY AN AUTORIZED TECHNICIAN.
The hand-dryer must only be installed on a closed surface, such as a wall,
partition or similar.
-13-