Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
CONTROL PANEL
Lift hood up/down
If you press the extract button
for 2 seconds, the hood begins to lift up and remain in
the highest position available. By again pressing the key, the hood retracts.
Important: Check that the core when moving in and out is not blocked or obstructed.
There is a risk that a container is lifted (handle, etc.) and possibly hot contents may spill.
Adjust the power intensity
In the working mode, short press
for increasing the speed by 1 level (from level 1 to
10). Long press to increase the speed to maximum level.
With the Silder, you can reduce or increase the power level. To do this, either directly
touch the desired intensity level or move back and forth on the control panel (under the
illuminated stepped bar) until you have reached the desired intensity. The power level is
displayed in the display above.
Turn of the automatic delay
Press the
button for three seconds. When starts to flash, the automatic delay is
activated.
37
Publicité
Chapitres
Table des Matières
Dépannage
