Risk Of Fire; Important - Beurer LR 220 Mode D'emploi

• Never block the air vents or grilles/outlets and do not place the device on a soft surface such as a bed or
sofa, as this could cause the device to tip over and block the air inlet or outlet.
• Do not place ANY objects on the device.
• DO NOT run the cable under the carpet.
• DO NOT cover the cable with carpets, runners or anything similar.
• DO NOT run the cable under furniture or equipment.
• DO NOT run the cable in high traffic areas.
• Lay the cable so that it does not pose a trip hazard.
• DO NOT attempt to repair or adjust any electrical or mechanical functions on this device. Failure to do so
voids your warranty. There are no user-serviceable parts inside the device. All maintenance work must only
be carried out by qualified personnel.
• To reduce the risk of fire or electric shock, do not use this device with a solid-state speed controller.
• Ensure that the openings of the device and the mains cable do not come into contact with water, steam
or other liquids.
• Never reach for a device that is submerged in water. Disconnect the mains plug immediately.

Risk of fire

WARNING
There is a risk of fire if the device is used improperly or these instructions for use are ignored.
• Never operate the device underneath a cover, such as a blanket, pillow, etc.
• Never operate the device near petrol or other highly flammable substances.
• To reduce the risk of fire, do not place the cable near heating coils, heating pads, ovens or radiators.
• Do not operate the device in close proximity to flammable or explosive gas mixtures.
• Keep the device away from sources of heat, as the housing could melt and trigger a fire.
Repairs
WARNING
• Only specialist personnel may perform repairs on electrical devices. Improper repairs may subject users to
considerable danger. For repairs, please contact Customer Services or an authorised retailer.
• Do not open the fan unit.
Handling

IMPORTANT

• After each use and before each cleaning, switch off the device and pull the plug out of the socket.
• Do not place any objects on the device.
• Do not expose the device to high temperatures.
• Protect the device against sunlight and impacts and do not drop it.
• Never shake the device.
• Place the device on a firm, level and dry surface.
• Ensure that the cable does not pose a trip hazard.
17