Safety Instructions; Start-Up - Atag UKB150 Close in Mode D'emploi

safety instructions

GB 8
This appliance may only be connected and
repaired by a recognised fitter.
The house mains to which you connect the
appliance must comply with the national and
local regulations.
Connect the appliance to a wall socket installed
in accordance with the current regulations.
If you have been supplied with a damaged
boiler, contact your supplier immediately.
Do not use an extension cable to connect up the
boiler.
Disconnect the plug from the wall socket during
repair work and cleaning.
Never pull the plug out of the wall socket by the
cable. Always grasp the plug firmly and pull it
straight out of the wall socket.
attention
The boiler's temperature selection knob is
childproof. The tap itself is not childproof!
warning
Do not use hot water as drinking water.

start-up

making the appliance ready for use
1. Open the main tap and, if necessary, the
stopcock of the inlet combination (WP). Check
the water connection for leaks.
2. Open the hot water tap. The boiler now fills up.
3. When water begins to run out of the hot water
tap, the boiler is full.
4. Next, insert the plug in the wall socket.
GB 9