GE Profile PTDS850GMWW Manuel De L'utilisateur Et Instructions D'installation page 10

About cycle options (cont).
10
NOTE: Not all features are available on all dryer models.
Estimated Time Remaining
Displays the approximate time remaining
until the end of the cycle.
As the cycle begins, you will see an initial
approximate total cycle time in the display.
Then lights will "race" in the display. This
means the dryer is continuously monitoring
Extended Tumble
Minimizes wrinkles by adding brief periods of
tumbling after cycle ends. The dryer will
tumble without heat for 10 seconds followed
by no tumbling for 5 minutes and repeat for
up to 3 hours after clothes are dry. The dryer
is in EXTENDED TuMBlE when the
ESTIMATED CyClE TIME display is
illuminated in a circular pattern.
Damp Alert
This option causes the dryer to beep when
clothes have dried to a damp level. Remove
items that you wish to hang dry. The DAMP
AlERT will only beep when this option is
selected (dry cycle keeps running).
Removing clothes and hanging them when
they are damp can reduce the need to iron
some items.
Delay Start
Use to delay the start of your dryer.
1. Choose your dry cycle and any options.
2. Press the DElAy START button. You
can change the delay time in 1-hour
increments (up to 24 hours) each time
you press the DElAy START button. Stop
pressing the button when your desired
time is displayed.
3. Press the START/PAuSE button to start
the countdown.
The countdown time will be shown in the
ESTIMATED TIME REMAINING display.
Rack Dry
Use the RACK DRy feature to dry shoes and
hats.
1. Insert the drying rack (refer to page 11 for
the correct placement).
2. Place garment in the center of the rack
and close the door.
3. Press the RACK DRy button.
4. Set TIME. (refer to page 8 for instructions).
5. Press the START PAuSE button.
the amount of moisture in the load. The lights
will continue until the dryer senses a low level
of moisture in the load. At that point, the
dryer will calculate and display the
approximate time remaining.
The light beside the button will light up when
EXTENDED TuMBlE is on.
NOTE: It is normal for the drum to pause
for short periods of time during EXTENDED
TuMBlE.
The light beside the button will light up when
DAMP AlERT is on.
NOTE: Only for LESS DRY, DRY, mORE DRY
and EXTRA DRY sensor dry selections.
The light beside the button will light up when
DElAy START is on.
NOTES:
n If the door is opened while the dryer is in
DElAy, the countdown time will continue
to count down the delay time. If the door
is not closed and the countdown time
expires, the cycle will not start until the
door is closed and the START/PAuSE
button is pressed.
n You can delay the start of a dryer cycle
up to 24 hours.
The light beside the button will light up when
RACK DRy is on.
NOTES:
n Do not use the drying rack without
selecting the RACK DRy cycle.
n Do not change the cycle setting off the
timed dry cycle.
n When the RACK DRy feature is selected
no other cycle setting can be chosen.An
invalid tone will sound if the cycle knob
is turned.