Installation - Funkwerk MULTI MODE COMPENSER Instructions De Montage

GB Installation

Installation

Risk of injury
Installing the device in inappropriate positions may cause injuries in
a road accident or render safety devices ineffective. Do not position
the ACTIVE COMBINER within the effective range of the airbags.
Disconnecting the negative terminal on the car battery
The negative terminal on the car battery must always be disconnec-
ted when working with the terminals on the vehicle's electrical
system. It is advisable to disconnect the negative terminal throug-
hout the whole installation.
The UMTS/GSM - MULTI MODE COMPENSER is installed as shown in Fig. 3.
First of all, install the provided 5 m HF cable between the mobile phone and the
COMPENSER (connection
Ensure that the connector audibly engages at the COMPENSER and tighten the
FME jack at the opposite cable end (torque: 1 Nm).
Then install the individually-prepared antenna cable between the COMPENSER
and mobile phone antenna and tighten the FME connector at the adapter cable
(torque: 1 Nm).
Now install the power supply cable between the COMPENSER and the connec-
tion points. Connect this to the connection cable side in accordance with the
colours shown.
First connect the earth lead (brown) to the connection point (terminal 31), then
the ignition lead (blue) to the fixed connection point (terminal 15) and finally the
constant positive lead (red) to the fixed connection point (terminal 30).
When working with these terminals, the negative terminal on the car battery
must be disconnected.
Then connect the power supply connector (socket connector on the connection
cable) to the COMPENSER (you must hear it lock in place).
Finally, screw in the COMPENSER using the four screws provided and reconnect
the negative cable to the car battery.
1).
-20-
UMTS/GSM-MMC