Funkwerk MULTI MODE COMPENSER Instructions De Montage page 16

UMTS/GSM-MMC
GB Introduction
Function principle
Fig. 1
To install the device proceed as follows:
First of all, use the illustration overleaf (Fig. 2) to check that you have all the com-
ponents. Have all the necessary tools at hand before starting installation. Refer-
ring to the criteria described in the "Installation" chapter, determine the instal-
lation position and the connection points for the power supply. Then install the
COMPENSER in the vehicle, following the instructions in the installation manual.
After installation
Reconnect the negative terminal on the car battery and check that the COMPEN-
SER has been installed correctly, as described in the "Installation, Putting into
Operation" chapter.
Good luck!
-16-