Safety Instructions - Funkwerk MULTI MODE COMPENSER Instructions De Montage

GB Safety instructions

Safety instructions

Disconnecting the negative terminal on the car battery
The negative terminal on the car battery must always be disconnec-
ted when working with the terminals on the vehicle's electrical
system. It is advisable to disconnect the negative terminal throug-
hout the whole installation.
Intended use
The COMPENSER is only suitable for 12 V vehicles with a negative
terminal to ground. It compensates for the cable losses of the con-
necting cables and is only to be operated in conjunction with an
external mobile phone vehicle antenna. The COMPENSER should
only be operated with GSM 900/1800/UMTS Band I mobiles or GSM
900/1800/UMTS Band I PC card modems.
Improper installation
Improper installation can cause damage to the device or vehicle.
Specific knowledge and skills are required to install the COMPEN-
SER. We recommend that the installation be carried out in a specia-
list workshop.
Risk of injury
Installing the device in inappropriate positions may cause injuries in
a road accident or render safety devices ineffective. Do not position
the COMPENSER within the effective range of the airbags.
Damage to important vehicle parts
Vehicle parts or leads may be damaged when drilling fixing holes or
tightening tapping screws. Please ensure there is sufficient space,
even behind the screws and drill holes.
Cable laying
When laid, cables should not be subjected to strain. Lay the cables in
such a way that they do not rub against each other or become crus-
hed. With the HF cable, the bend radius may not lie below 3 cm!
-14-
UMTS/GSM-MMC