FORGE ADOUR Origin Série Notice D'utilisation page 18

Precautions for use
To ensure safe use of your FORGE
ADOUR plancha, it is essential to comply
with the different rules for installation and
use below:
•Remember to
adhesive film from the stainless steel parts.
•Between use, be sure to close the liquid gas
bottle valve.
•This is a gas heated appliance intended for
outdoor use only; indoor rooms, garages,
cellars, canteens, caravans, boats are not
locations for its use. Open gardens, open
patios or breezaways can be considered as
outdoor locations.
•Do not store or use flammable products or
vapours near the plancha.
•If there is a smell of gas, close the liquid gas
bottle valve and never operate the appliance.
•If the appliance is placed on a support
(table, etc.), it must imperatively be fitted
with its 4 legs and the supporting table must
be made in a heat resistant material (not in
wood).
•Your FORGE ADOUR plancha is not
connected to a combustion product discharge
system. It must be installed and connected
in accordance with the installation rules in
force.
•Warning: some accessible parts may be
very hot. Keep young children away and
don't touch mettalic parts of plancha until all
surfaces have fully cooled down (30 minutes
after the turninf off for the burners).
•Do not move the appliance while in
operation. Check the ground or support is at
level without slope.
•Do not use an adjustable pressure relief
valve.
•Allow the plancha to cool before cleaning
the chassis and handling the grease tray.
18
remove the protective
•Make sure that the hose is not in contact
with the hot parts of the appliance.
•If your appliance is protected by a soft
cover, be sure to remove it completely before
using the plancha.
•If your plancha is equipped with a lid, make
sure that this lid is in the "OPEN" position
while heating and in use.
•For use without a FORGE ADOUR wheeled
unit or support: the gas bottle (13 kg) which
supplies the plancha must be placed 80 cm
away from the appliance.
•If the plancha is to be used on a wheeled
unit or support, it is essential to use a bottle
weighing 6 kg max.
•Warning: tightness is to be checked
outdoors, away from any source of ignition.
•Make sure that the control switches are in
the closed position. After opening the bottle
and resetting the pressure relief valve, check
that there are no bubbles on all fittings,
on the pressure relief valve and on the
appliance, using soapy water. The presence
of bubbles indicates a leak.
Before any use check the plancha cooking
plate is clean and gas controls in order
to work; verify the burners holes and gas
nozzle zone is free from dirty, dust or insects
leavings. A clogged gas jet could lead to fire
and danger for users.
Close the gas bottle and tighten all the
fittings.
Repeat the tightness test. If the leak comes
from the appliance, do not use your plancha
and contact the manufacturer or the retailer.
Test the tightness every time the bottle is
replaced.
Danger: never test the tightness of your
appliance with a flame. Never use a leaking
appliance.