Parts List - Warn ProVantage 72 Instructions D'installation

IV. Installation
1. Attach the wear bar to the plow blade as shown in
figure 1. Place 10mm dia carriage bolts through
each of the square holes in the wear bar, and
through their respective holes on the blade. Ter-
minate with a 10mm lock nut.
2. Attach the heavy-duty plow skids to the plow
blade. Slide the skid into the skid sleeve toward
the edges of the plow blade. Terminate with a
hitch pin by running the pin through one of the
three skid sleeve holes and through the desired
skid hole. Be sure to lock the retaining pin when
completed to prevent losing the pin and skid dur-
ing plowing.
NOTE: Refer to Warn Plowing Operators guide to
determine where to set the skid height during
plowing.
Installation of the plow blade to the push tube as-
semble continues in the push tube installation in-
stuction manual.
WARN® INDUSTRIES
III. Parts List
Part # Qty Description
79756 1 72" Plow Blade
70906 1 72" Wear Bar
79882 9 10mm Carriage Bolt
69807 9 10mm Lock Nut
84671 2 Heavy Duty Plow Spring
77907 2 Heavy Duty Plow Skid
79938 2 Retainer Pin
WEAR BAR INSTALLATION
PAGE 3
FIGURE 1
79959 Rev A1