Important Safety Information - Anker PowerConf Mode D'emploi

Important Safety Information

• Avoid dropping.
• Do not disassemble.
• Do not install near any heat sources.
• Do not place any sources of danger on this device (e.g. liquid filled objects, lit candles).
• Use original or certified cables.
• Clean with a dry, soft lint-free cloth. Do not use any corrosive cleaner or oil.
• Do not expose batteries to high heat as direct sun light, fire and or the like.
Notice
This product complies with the radio interference requirements of the European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance with the essential requirements
and other relevant provisions of Directive 2014/53/EU.For the declaration of conformity, visit the Web
site:www.anker.com.
Due to the used enclosure material, the product shall only be connected to a USB Interface of version 2.0 or higher.
Do not use the Device in the environment at too high or too low temperature, never expose the Device under
strong sunshine or too wet environment.
The suitable temperature for the product and accessories is -10~40℃ .
When charging, please place the device in an environment that has a normal room temperature and good
ventilation.
It is recommended to charge the device in an environment with a temperature that ranges from 5℃ ~25℃ .
RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a
distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure
requirement, use product that maintain a 20cm distance between the device and human body.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS
Bluetooth Operating Frequency Range ：2402~2480MHz; Bluetooth Max Output Power:8dBm(EIRP)
The following importer is the responsible party (contact for EU matters only)
Importer:Anker Technology (UK) Ltd
Importer Address:Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United Kingdom
This product is designed and manufactured with high quality materials and components, which can be
recycled and reused.
EN 01
This symbol means the product must not be discarded as household waste, and should be delivered to an
appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources,
human health and the environment. For more information on disposal and recycling of this product, contact
your local municipality, disposal service, or the shop where you bought this product.
FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
(1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect
the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an
experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
The following importer is the responsible party
Company Name: Fantasia Trading LLC
Address: 9155 Archibald Avenue, Suite 202, Rancho Cucamonga, CA, 91730, US
Telephone: +1 (800) 988 7973
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure
condition without restriction.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Trademark
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth
SIG, Inc. and any use of such marks by Anker Innovations Limited. is under license.
02 EN