Description Of The Appliance; Operation - Kärcher AD 2 Mode D'emploi

Description of the Appliance

Illustrations on fold-out page!
The scope of delivery of your appliance is
illustrated on the packaging. Check the contents of the
appliance for completeness when unpacking.
In the event of missing accessories or any transport
damage, please contact your dealer.
1 Suction hose connection
2 Handle
3 ON/OFF switch for appliance
4 Filter cleaning system connection
5 Filter cleaning button
6 Carrying handle/cable hook/leaning position
7 Exhaust grille and exhaust filter
(already installed in the appliance)
8 Container closure
9 Mains cable with mains plug
10 Accessory mount
11 Steering roller
12 Handle/skirting protection
13 Flat fold filter with frame
(already installed in the appliance)
14 Filter basket
15 Suction hose with handle
16 Suction tubes 2 x 0.5 m
17 Floor nozzle
ATTENTION
Flat fold filters and the associated frame must always be
inserted during use.
Before Startup
 Illustration
Remove the appliance head and the filter basket.
Mount loose parts deliverd with appliance prior to
start-up.
 Illustration
Insert filter basket.
Insert and lock the appliance head.
WARNING
Check whether the appliance was emptied and cleaned
during the last vacuuming cycle.
The use of dust collection bags is not permitted.
Illustration -
Depending on equipment
Connect accessories.
 Slide the suction hose into the connection, it will
lock into place.
In order to disconnect it, push down with your
thumb and pull the suction hose out.
 Connect both suction pipes and connect them to
the suction hose.
16

Operation

Start up
 Join suction pipes and floor nozzle together.
Illustration
 Plug in the mains plug.
Illustration
 Turn on the machine.
Position I: Suction operations
Interrupting operation
 Turn off the appliance.
Position 0: Appliance is switched off
Illustration
 Place suction hose with handle and accessories in
the trough of the cable hook.
Illustration
 Place suction hose with handle in the trough of the
cable hook.
Integrated filter cleaning system
The filter cleaning system is intended for intermediate
cleaning when vacuuming large amounts of ash.
Note: Thanks to the filter cleaning system the soiled flat
pleated filter can be cleaned at the push of the button
and the suction performance can be increased again.
Illustration
 Insert the handle of the suction hose into the filter
cleaning system connection on the device head.
Press the filter cleaning button three times with the
device switched on, waiting 4 seconds between the
individual actuations.
Note: After operating the filter cleaning button several
times, check the container for its filling volume. Other-
wise, the dirt might escape when the container is
opened.
 Turn off the appliance and disconnect the mains
plug.
Empty the container
Illustration
 Take off the device head.
 Remove the filter basket.
 Empty the container.
 Clean the flat fold filter as needed.
Storing the appliance
Depending on equipment
Illustration
 Stow away the mains cable and accessory at the
machine. Store the appliance in a dry room.
– 9
EN
Finish operation