Storage; Guarantee; Technical Data; Possible Faults - ATIKA KSG 220 A Instructions D'utilisation

Clean the machine only dry.
Do not use solvents for the synthetic parts (petrol, alcohol,
etc.) as these can damage the synthetic parts.
Never use any grease!
Use environmentally acceptable spray oil.

Storage

pull out main plug
Store unused equipment in a dry, locked place out of the
reach of children.
Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
− thoroughly clean the device

Guarantee

Please observe the enclosed terms of guarantee.

Possible faults

Before each fault clearance
− switch off device
− wait for the shutdown of the grinding wheel
− pull out main plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Chain sharpener does not operate.
Chain sharpener
interruptions
Grinding wheel becomes hot
Motor is humming, grinding wheel stops
Unusual vibrations
Possible cause
no power
Extension cable defect
Main plug, motor or switch defect
Extension cable defect
grinds with
Internal fault.
ON/OFF button defective.
Grinding wheel is dull or defective
Grinding wheel is blocked
Grinding wheel is defective

Technical data

Type
Model
Motor rating P
1
Cutting speed v
Mains voltage / Mains frequency
Hand-arm vibration a
Grinding wheel
Ø x thickness x hole Ø
Weight appr. 2 kg
Remedy
Check power supply, power socket and fuse
protection
Check extension cable, exchange defect
cable immediately
Have motor or switch checked by an
approved electrician or replaced by original
spare parts
Check extension cable, exchange defect
cable immediately
Please contact the after sales service.
Please contact the after sales service.
Replace grinding wheel
Remove object
Replace grinding wheel
15
KSG 220 A
KSG 220 A
220 W
~ 40 m/s
230 V~ / 50 Hz
3,52 m/s
2
vhw
Ø100 x 3,2 x Ø 10 mm
(Ø 100 x 4,5 x Ø 10 mm)