Preparing For Commissioning; Switching Off; Working Instructions - ATIKA KSG 220 A Instructions D'utilisation

Preparing for commissioning

To achieve perfect function of the machine, follow the
notes given in these instructions
You must still do the following:
Mount the rotary table
Set up the device securely
Assembling the rotary table
1. Place the rotary table (1) onto the supporting table (2).
2. Thread the mounting nut (7) on the locking screw.
Mounting the chain sharpener on a workbench
For secure handling, the device must be mounted along the
edge of a workbench or table (see
all three fixing points if possible. But make sure that the recess
for the saw chain remains free and the locking nut remains
accessible.
Hint: We recommend the additional placement of a rubber pad
to reduce noise and vibration (not included in scope of
delivery).
The small parts required for mounting are not included in the
scope of delivery. Use the following for this purpose:
Position Description
1. Hexagonal screw M 8
2. Washer Ø 8mm
3. Hexagon nut M 8, self-locking
Place the device at a location that meets the following
conditions:
− secured against slipping
− free of vibrations
− even
− clean and dry
− free of tripping hazards
− adequate light
A
A , bottom illustration). Use
Commissioning
Mains connection
Compare the voltage listed on the device type plate, e.g.
230 V, with the mains voltage and connect the chain
sharpener to the corresponding and properly grounded socket.
Alternating current motor: Use a shockproof plug, mains
voltage 230 V with residual current circuit breaker and 10
A inert fuses.
Use connection cable or extension cable respectively with
a cross section of at least 1,5 mm².
Switching on
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
Press "I" of the ON-OFF switch.

Switching off

To turn off the device, press "0" of the ON-OFF switch.

Working instructions

Before commencing work, ensure the following:
Workplace tidied?
Has the chain sharpener been permanently mounted on a
workbench?
You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Working with the chain sharpener
The protective cover (20) must cover the grinding
wheel as much as possible.
For this slacken the both screws (14) and adjust the
protective cover appropriately.
Always keep your hands at a safe distance to the
rotating grinding wheel.
Use the factory-installed grinding wheel only to sharpen
chains used in hobby applications (1/4, 3/8 hobby and
0.325 chains).
100 x 4.5 x 10 mm, item no. 363718, is available for
professional cutting chains.
Do not use any damaged grinding wheels or such that
have changed their shape.
Start working only after the grinding wheel has reached its
maximum speed.
Only chains may be worked that can be put down and
guided securely.
Ensure that you always comply with the safety
instructions given on p. 11
13
C
(An optional grinding wheel