Installation Instructions; Temperature Adjustments; Installation Limitations - Rotel U905CH1 Mode D'emploi

• INSTALLATION INSTRUCTIONS

Remove the inner and outer packaging.
o
o Allow the appliance to rest for two hours before switching it on.
o Clean the inside using a soft cloth and lukewarm water.

• TEMPERATURE ADJUSTMENTS

o Your wine cooler has a touch screen control on the front of the unit. You can set the
temperature of your wine cooler to any setting you desire. The temperature ranges
from 11℃ to 18℃.
o NOTE: the white wine temperature is cooler than for red wine.
o By touching the «▲» temperature button on the display, you can increase the tem-
perature and touching the «▼» temperature button will lower the temperature.
Your wine cooler also has a light for your viewing pleasure. A light switch on the con-
trol panel will activate the light manually. Under normal operation, it is best for the
light to remain off.
o This cooler uses superconductor heat-pipe refrigeration technology (no compressor)
and is not designed for use in hot areas like garages, warehouses or outdoors since it
is designed to operate at a maximum of 32 degrees below the ambient temperature.
o When the ambient temperature is below the pre-set temperature, the wine cooler
will not operate until the ambient temperature goes over the pre-set temperature.

• INSTALLATION LIMITATIONS

o Do not install your wine cooler in an insulated or heated location e.g. garage etc.
o Avoid placing the unit where there may be electrical interference.
o Your wine cooler is designed to be free-standing only. It is not designed to be built-
in.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
33