Before First Use - Vollrath JT2HC Manuel D'utilisation

BEFORE FIRST USE

1. Clean the toaster. See "Cleaning" on page 5.
OPERATION
This toaster ships set up to toast bread. To toast sandwiches, see See
"Convert to A Pass through Toaster" on page 4.
CAUTION
Burn Hazard
Do not touch the equipment while it is heating or operating.
Hot surfaces can burn skin.
NOTICE: The crumb tray must be installed in the toaster during
operation. Failure to install the crumb tray will cause the
toaster to overheat.
Adjust the Heat Shield
Excess space above the product will create heat loss and may reduce
performance.
1. When the equipment is cool to the touch, use a screwdriver to
loosen the screw on the heat shield.
2. Grasp the shield and pull it up or down to adjust the opening so the
tallest products can pass through. Re-tighten the screw.
Preheat
1. Plug the toaster into a grounded electrical outlet that matches the
rating on the name plate found on the side of the toaster.
NOTICE: Using a voltage other than the nameplate rated voltage
will cause damage to the unit. Incorrect voltage,
modification to the power cord or electrical components
can damage unit and will void the warranty.
2. Rotate the power knob(s) to the full power position (I).
3. Set the conveyor speed control knob(s) to 7.
4. Rotate the top and bottom heat control knobs to high.
5. Wait 5 minutes for the toaster to preheat.
Convertible Conveyor Toasters, 300-900 Slices Per Hour* Operator's Manual - Models JT2HC and JT3HC
Test
1. Adjust the settings for the product to be toasted.
Tips
Product
Bagels, wheat or rye bread or
products with high moisture
content.
Buttered or coated, such as
pastries
Frozen
Sandwiches
2. Test the settings by placing a sample of the food to be toasted onto
the feed ramp. Place bagels or buns onto the feed ramp with the cut
side facing up.
For One-Sided Toasting
TOP heat control to the desired setting.
BOTTOM heat control to the OFF position.
Toast Bread or Sandwiches
1. Adjust the top and bottom heat control settings and conveyor as
needed for even toasting. Allow time for the toaster to adjust to new
heat settings before placing bread or sandwiches on the
2. For best performance do not overload the toaster. Wait a few
seconds before loading a second row of bread or sandwiches into
the toaster.
If an Item Becomes Stuck
1. Rotate the power knob to the OFF position (O) and unplug the
equipment.
2. Let the equipment cool completely. Use tongs to remove the item.
Take care to not bump the heating elements above and below the
conveyor.
Suggestions
Use a slower conveyor speed.
Not recommended.
Must be thawed before toasting.
Use slower conveyor speed to allow
protein ingredients to heat. Set
bottom heat control low.
conveyor.
3