Overview Of Powerhead Controls; Programming Overview - Genie SILENTMAX 1000 3042 Instructions D'installation

4

OVERVIEW OF POWERHEAD CONTROLS

This section describes the simple programming
functions. Use this page to familiarize yourself with the
buttons and LED indicators used to program the opener.
NOTE: These and buttons are for programming use
only. Do NOT use these buttons to operate the opener.
Programming
buttons location
on powerhead.
FIG. 4-1 Locate programming buttons
There are three programming buttons and two lights
(LEDs) on the powerhead.
ROUND
LED Indicator
(Light)
Facing
Garage Door
LONG
LED Indicator
(Light)
FIG. 4-2 Programming buttons
Each of the buttons are used to enter and complete
the setup programming. The LEDs indicate status or a
function change by illuminating ON, OFF, or ON flashing
in one of three different colors: BLUE, RED, or PURPLE.
Throughout the instructions in this manual the buttons
and LEDs are also displayed as icons.
Buttons
Name
Program button
Close Travel button
Open Travel button
LED Colors
Round Red
Round Purple
Round Blue
14
To garage door
Close
Travel
Button
PROGRAM
SET
Shape Use
PROGRAM
Enters into and selects
programming menus
SET
multi-function;
moves door, advances
through menus
multi-function;
moves door, advances
through menus
and Long Red
and Long Purple
and Long Blue
©2011 The Genie Company

Programming Overview

There are four Powerhead program menus:
Remote Program (Default menu)
Limits Program
Speed Program*
Force Program*
Programming steps for Limits and remotes are found on
pages 6 through 10.
*Force and Speed settings are set at the factory and do
not normally require adjustment programming. Custom
programming instructions for Speed and Force are
located in the Troubleshooting Section of this manual.
These are the basic steps to enter into the four
programming menus:
PROGRAM
Open
1. Press
Travel
SET
then release.
Button
2. Both LEDs go out and Round BLUE light comes
ON. You are in the Program Menus at the Remote
Programming.
By using the
the Limits, Speed, or Force program menus and the
LED display will change accordingly.
Each program menu has a specific LED display.
Press
Default
X2
X3
PROGRAM
3. Press
functions. SET
If you have entered into an unwanted program menu
and are not sure where you are - do not press any
buttons for 30 seconds. The programming function
will time out after 30 seconds if there is no key stroke
activity.
and hold until both BLUE lights come ON
or the button you can navigate to
Program LED Display
Remote Round Blue
Limits Long Blue
Speed Round Blue
Force
Round Red
button to enter into the program menu
& Long Blue
3/2011