Installation And Initial Operation; Recommended Precautions - Cattani Micro-Smart Manuel D'utilisation

• Installation and initial operation

• Recommended precautions

Before unpacking the appliance, check the warning shock-
watch on the carton. In the case of it being red or the car-
ton being damaged, accept the material while reserving the
right to examine the machine.
Unpack the appliance following the instructions shown on
the package. The carton is recyclable. Dispose of it in com-
pliance with regulations in force. Retain the plastic caps
that cover all inlets and outlets of the unit, as they must
be used if the machine needs to be moved or transported.
The machine installation must be carried out by a specia-
list, equipped with the necessary tools. Install the applian-
ce in a clean location, far from heat sources, humidity and
dust. Micro-Smart can be installed outdoors (on a balcony,
in veranda or gardens), provided that it is sheltered from
rain, humidity, frost and direct sunshine.
For outdoor installation we recommend the use of our
special designed box fi tted with double isolating roof, anti-
freeze and ventilation systems (both fi tted with fi xed ther-
mostat for automatic temperature control).
In the plant room temperature can range from a minimum of
+ 5 °C to +35 °C max.
Micro-Smart fi tted with box, for indoors or outdoors instal-
lation, can be supplied with antifreeze device. In the case of
the plant room requiring ventilation or air-conditioning, we
suggest that you contact a thermo-technician for a tailored
solution. The plant room must be closed to patients and
extraneous people. If such a room is not available, machi-
nes must be protected by a suitable cover, which must not
be easy to remove. Use protections and danger warning
boards to prevent accidental risk from electrical shocks,
and/or the possibility (unlikely but not excludible) of fi re,
explosion and contaminating air or liquid leakage. Only use
boxes and covers, be them for indoors or outdoors, that
are designed and produced by the manufacturer.
Keep the plant room free from fl ammable material. Make
sure that there is no possibility for gas leakages. Do not
connect damaged appliances to the mains power supply.
Do not use extension leads, multiple plugs or sockets. Be-
fore connecting the machine to the mains, ascertain that
the feeding line is complying with the regulations C.E.I.
64-8 and that a thermal switch and a residual current ope-
rated circuit-breaker (class A or B) (16A) according to the
regulations EN 61008-1 are installed. Light coloured, woo-
den, linoleum, rubber or marble fl oors can change colour or
be marked if they are kept in contact with rubber vibration-
proof devices (1). Therefore, it is necessary to use a rubber
sheet or some other suitable material to isolate vibration-
proof devices from the fl oor.
28
HANDLE
WITH CARE
WARNING
WARNING
R
SHOCKWATCH
RED INDICATES ROUGH HANDLING
IF RED, NOTE ON BILL OF LADING
INSPECTION MAY BE WARRANTED
MODEL L-55 (37g)
1