Backup - CDVI U4GO Série Instructions De Montage

BACKUP

Upload or dowload the full data-ase using an external memory card
1) Plug-in the memory into the connector (Red Rubber Memory = 512 Kbit)
Restoring from the external memory will overwrite ALL
!
module database .
OPTION
The menu "Option" allows you to enable ("ON " or "OFF") the "Auto-installing" feature.
The "Auto-installing" feature allows you to register other remote controls from any remote control already
memorized in the module.
IMPORTANT NOTE: One remote must be memorized in the receiver.
Memorization of a new remote (Tx)
Place the two remote ("Memorized Tx" and the "New Tx") next to each other then do the following:
LED Blinks
"Memorized Tx"
Press & hold A+B buttons
simultaneously for 3 Sec :
The LED blinks slowly
See note #1
"New TX"
IMPORTANT NOTES :
1 . Must be a remote already memorized in the receiver.
2 . If you press any button of the authorized "New Tx" out of reception range of the receiver more that 15
times, the autoinstalling property stops and the procedure must be restarted.
28
A6U48 - A10U48
Mid & Long Range UHF Reader
LED Blinks
"New Tx"
Within 15 sec., press & hold
A+B buttons simultaneously
of the "NEW Tx" for 3 Sec :
The LED blinks slowly
Receiver
Long Beep
Scroll until
"menu Backup"
then press "P3"
m e n u
B a c k u p
LED turns off
"Memorized Tx"
Within 15 sec. press & hold
the "A" button of the
"Memorized TX" for 1 sec.:
The LED turns off
Once the new remote has been "Authorized", stand next to the
receiver and press button A for 1 sec .
The receiver makes a long beep: The remote has been
memorized and is ready for use.
It may take up to 6 seconds for the receiver before hearing the
confirmation beep of a "New Tx" .
EN
Scroll to desire
backup option
then press "P3"
B a c k u p
t o
Module to
memory card
B a c k u p
f r o m
Memory card to
module
LED blinks
quickly
"New Tx"
The LED of the
"New Tx" blinks quickly :
Auto-installing is authorized.
See note #2