Configuration - CDVI U4GO Série Instructions De Montage

EN

CONFIGURATION

Wiegand Output Settings
Scroll until
"menu Config"
then press "P3"
m e n u
C o n f i g
Relay Output Settings
Scroll until
"menu Config"
then press "P3"
m e n u
C o n f i g
Relay activation per remote buttons
Scroll until
"menu Config"
then press "P3"
m e n u
C o n f i g
Mid & Long Range UHF Reader
Scroll to desire
Wiegand setting
then press "P3"
W i e g a n d B i t
B i t 2 6
W i e g a n d F i l t e r
F i l t e r A - - D
Scroll to desire Scroll to desire
relay setting then relay setting then
press "P3" press "P3"
C o n f i g
R e l a y 1
C o n f i g
R e l a y 2
E d i t T X
N # 0 5 2
P o s 0 0 1
1 2 3 4 5 6 7 8
R e l a y 1
A B - -
R e l a y 2
- - - D
A6U48 - A10U48
Set the Wiegand protocol to:
26, 30 or 44 bit (default 26-bit)
B i t
Select the buttons that will be use to
transmit the Wiegand data.
R e l a y 1
P u l s e
R e l a y 1
S t e p
R e l a y 1 h h
T i m e d 0 0 : 0 0 : 0 0
Use "P1" and "P2" to set the
values, then "P3" to confirm and
R e l a y 1
shift left, press "P4" to go back .
D i s a b l e d
The system shows the total number of remotes
memorized. [Example = 52]. Use "P3" to confirm and
display the list.
Scroll the list using "P1" and "P2" . Once found the
serial number of the remote to modify, press "P3" .
Select the remote buttons that activate the relay 1. Use
"P1" and "P2" to set the values, then "P3" to confirm
and shift right. [ Example: A & B].
Select the remote buttons that activate the relay 2. Use
"P1" and "P2" to set the values, then "P3" to confirm
and shift right. [ Example: D].
Press "P3" to return to the list or "P4" to exit.
m m s s
27