Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. How to prepare the ALMEMO® 470 MeshViewer
3.3 How to establish an Ethernet Con-
nection between the ALMEMO
MeshViewer and the ALMEMO
Wireless Data Logger
®
! The ALMEMO
! There must not be a connection between the ALMEMO
and the software ALMEMO
1. Switch the ALMEMO
2. On the data logger set the operating mode "... with network monitoring"
(see Instruction Manual ALMEMO
How to set the Data Logger, subchapter How to set the Operating
Mode).
❑ When you want to connect to the ALMEMO
the operating mode "... with network monitoring" must always be reset af-
ter the data logger has been switched off and on then again.
3. Connect the data logger with the PC via an Ethernet network (see In-
struction Manual ALMEMO
the Data Logger to a PC).
4. In the software window
Connection Type
5. In the drop down menu click on
6. Click on the field
logger you will find the IP address in the menu Settings>Device set-
tings>Communication).
Connect.
7. Click on
➢ In the main window of the ALMEMO
CONNECTED will now be displayed instead of DISCONNECTED.
➢ The data logger is represented by a larger circle. The connected wireless
sensors are represented by smaller circles.
➢ When a wireless sensor that was already displayed as connected in the
®
ALMEMO
470 MeshViewer software is no longer reachable it will be
represented by a grey circle.
➢ Wireless sensors whose Sleepmode is activated are represented by
dashed circles.
➢ The radio connections between the data logger and the wireless sensors
are represented by arrows.
- 16 – English
470 MeshViewer software must be started.
®
Control or the software AMR WinControl.
®
470 wireless data logger on.
®
470 data logger, chapter How to connect
SETTINGS
.
IP
enter the IP address of the data logger (on the data
®
470 Wireless data logger, chapter
®
470 MeshViewer software,
click on the drop down menu next to
TCP/IP
.
®
470 MeshViewers the text
®
470
®
470
®
470 wireless data
Publicité
Table des Matières
