Ahlborn ALMEMO 470 MeshViewer Mode D'emploi page 15

3. Connect the data logger with the PC via an USB data cable (see Instruc-
tion Manual ALMEMO
ta Logger to a PC.
4. Start the ALMEMO
5. In the software window
Connection Type
to
6. In the drop down menu click on
on the drop down menu featuring the COM port selection.
8. Connect the data logger with the PC via a USB cable (see Instruction
Manual ALMEMO
Logger to a PC, subchapter How to establish a USB Connection).
9. Click on the desired COM port number, the data logger is connected to
(to determine the COM port number, see Instruction Manual ALMEMO
470 data logger, chapter How to establish a USB Connection, section
Identify the COM port number).
10. Click on the drop down menu featuring the baud rate selection.
11. Click on the baud rate set in the data logger (the baud rate is displayed
in the menu Settings>Device Settings>Communication).
Connect
12. Click on
➢ In the main window of the ALMEMO
CONNECTED will now be displayed instead of DISCONNECTED.
➢ The data logger is represented by a larger circle. The connected wireless
sensors are represented by smaller circles.
➢ When a wireless sensor that was already displayed as connected in the
®
ALMEMO 470 MeshViewer software is no longer reachable it will be
represented by a grey circle.
➢ Wireless sensors whose Sleepmode is activated are represented by
dashed circles.
➢ The radio connections between the data logger and the wireless sensors
are represented by arrows.
3. How to prepare the ALMEMO® 470 MeshViewer
®
470 data logger, chapter How to connect the Da-
®
470 MeshViewer software.
SETTINGS
.
USB (COM).
®
470 data logger, chapter How to connect the Data
.
click on the drop down menu next
7. In the line
®
470 MeshViewers the text
COM
click
®
- 15 – English