How To Prepare The Almemo; How To Install The Almemo; How To Establish A Usb Connection Between Almemo ® 470 Meshviewer And Almemo; 470 Meshviewer - Ahlborn ALMEMO 470 MeshViewer Mode D'emploi

3. How to prepare the ALMEMO

470 MeshViewer

3.1 How to install the ALMEMO

MeshViewer on the PC and how to start
it
❑ This installation instruction applies to all Windows versions from Win-
dows 7 upwards.
1. Download the software ALMEMO
link:
https://www.ahlborn.com/en_UK/service/downloads/software
2. Unzip the file folder.
3. Open the file folder.
4. Double-click on the file named
vX.X.exe.
Two software windows of the software ALMEMO
Viewer will open.
3.2 How to establish a USB Connection
between ALMEMO
and ALMEMO
ger
®
! The ALMEMO
! There must not be a connection between the ALMEMO
and the software ALMEMO
1. Switch the ALMEMO
2. On the data logger set the operating mode "... with network monitoring"
(see Instruction Manual ALMEMO
How to set the Data Logger, subchapter How to set the Operating
Mode).
❑ When you want to connect to the ALMEMO
the operating mode "... with network monitoring" must always be reset af-
ter the data logger has been switched off and then on again.
- 14 – English
®
470 Wireless Data Log-
470 MeshViewer software must be started.
®
Control or the software AMR WinControl.
®
470 wireless data logger on.
®
470 MeshViewer under the following
ALMEMO® 470 MeshViewer
®
470 MeshViewer
®
470 Wireless data logger, chapter
®
470 MeshViewer software,
®
470
®
470 Mesh-
®
470 wireless data
®