Using The Appliance - Philips Lumea Comfort SC1982 Mode D'emploi

ENGLISH
16
6 Stop testing. Wait for 24 hours and then check your
skin for any reactions. If you see no skin reactions,
you can use the intensity level last used at your next
treatment of this body part.
Note: If your skin shows a reaction, wait for the reaction to
disappear. Then treat the body part at the intensity level below
the one that produced a reaction, wait for 24 hours and check
for skin reactions again.
7 Perform steps 1 to 5 for each body part you intend
to treat.

Using the appliance

Always perform a skin test (see chapter 'Preparing for
use') before you start using the appliance according to the
instructions below.
1 Insert the small plug into the appliance socket and
insert the adapter into a wall socket.
2 Press the on/off/intensity button. The light of
intensity level 1 goes on and the fan inside the
appliance starts.
3 After about 1 second, the READY/skin colour
warning light comes on. This shows that the appliance
is ready to release a flash.