Features; Product Specifications; Assembly - Homelite HLCA80710 Manuel D'utilisation

PRODUCT SPECIFICATIONS

Engine .................................................................................................................................................................. 163 cc OHV
Fuel Tank Capacity .................................................................................................................................... 0.29 gal (1.1 liters)
Maximum Pounds Per Square Inch Pressure* ......................................................................................................... 2,500 psi
Maximum Gallons Per Minute* .................................................................................................................................. 2.3 gpm
Maximum Inlet Water Temperature ................................................................................................................................104˚F
KNOW YOUR PRESSURE WASHER
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
ENGINE SWITCH
The engine switch is used in combination with the recoil
starter grip to start the engine. It is also used to turn the
engine off.
FUEL TANK
This fuel tank has a maximum capacity of 0.29 gal. (1.1 liters).
Use unleaded automotive gasoline in the engine.
HOSE STORAGE
Once the high pressure hose is rolled, hang it on the back of
the machine using the stretch strap to secure in place.
OFF SWITCH
To turn the engine off, press and hold the OFF switch for a
full three seconds or until the engine stops.
UNPACKING
This product requires assembly.
 Carefully cut the box down the sides then remove the
tool and any accessories from the box. Make sure that
all items listed in the packing list are included.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-866-340-3912 for assistance.

FEATURES

RECOIL STARTER
The recoil starter is pulled to start the machine.
SPARK ARRESTOR
This engine is not factory equipped with a spark arrestor.
In some areas it is illegal to operate an engine without a spark
arrestor. A spark arrestor is available by calling customer
service for assistance.
THERMAL RELIEF VALVE
This pump feature will prevent water temperatures from
reaching harmful levels by releasing a small amount of water
from a rubber hose. Once the water has drained, the thermal
relief valve will reset itself.
TRIGGER HANDLE
The trigger handle has a gripping surface that provides added
control of the spray wand and helps reduce fatigue.
TRIGGER WITH LOCK OUT
Pulling the trigger releases a stream of water for high
pressure cleaning. The lock out provides protection against
unauthorized use.

ASSEMBLY

PACKING LIST
Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-Connect Nozzle (4)
Injection Hose
Injection Hose Filter
Wheel (2)
Flat Washer (2)
Axle (2)
Axle Sleeve (2)
Hitch Pin (2)
4-Cycle Engine Oil (SAE 30 or SAE 10W30)
Handle
Operator's Manual
Page 7 — English