Features; Product Specifications; Tools Needed; Assembly - Homelite UT80709 Manuel D'utilisation

PRODUCT SPECIFICATIONS

Fuel Tank Capacity .................................................................................................................................................... 0.22 gal.
Oil capacity .................................................................................................................................................................... 20 oz.
Maximum Pounds Per Square Inch Pressure* ......................................................................................................... 2,700 psi
Maximum Gallons Per Minute* ...................................................................................................................................2.4 gpm
Maximum Inlet Water Temperature ................................................................................................................................104˚F
*Max. rating determined by PWMA Standard 101
KNOW YOUR PRESSURE WASHER
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
5-IN-1 CHANGE OVER NOZZLE
The 5-in1 Change Over Nozzle makes it easy to change
spray patterns.
FUEL TANK
This fuel tank has a maximum capacity of 0.22 gal. Use
unleaded automotive gasoline in the engine.
FUEL VALVE
The fuel valve must be open to start the engine and should
always be closed before storing the machine.
HOSE STORAGE
Once the high pressure hose is rolled, hang it on the back of
the machine using the hook-and-loop strap to secure in place.
ON/OFF SWITCH
The on/off switch is used in combination with the starter
grip and rope to start the engine. It is also used to turn the
engine off.
The following tools (not included or drawn to scale) are needed for assembly:
See Figure 1a.
 7/16 in. wrench
 Phillips head screwdriver
UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.

FEATURES

STARTER GRIP WITH ROPE
The starter grip with rope is pulled to start the machine.
SPARK ARRESTOR
This engine is not factory equipped with a spark arrestor.
In some areas it is illegal to operate an engine without a spark
arrestor. A spark arrestor is available by calling customer
service for assistance.
THERMAL RELIEF VALVE
This pump feature will prevent water temperatures from
reaching harmful levels by releasing a small amount of
water. Once the water has drained, the thermal relief valve
will reset itself.
TRIGGER HANDLE
The trigger handle has a gripping surface that provides added
control of the spray wand and helps reduce fatigue.
TRIGGER WITH LOCK OUT
Pulling the trigger releases a stream of water for high
pressure cleaning. The lock out provides protection against
unauthorized use.

TOOLS NEEDED

ASSEMBLY

Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
Page 7 — English
WARNING: