Arm Training; Display Functions; Setting Values To Zero; Troubleshooting - Crivit 274619 Notice D'utilisation

Arm training (figure J)
1. Place the article in front of you on a level,
stable, and non-slip surface (e.g. at table
height) and sit in front of it in a relaxed posi-
tion on a chair with your back straight.
2. Place the palm of your hand on the pedals
in such a way that the pedal strap is over your
hand.
3. 'Ride' the bicycle with your hands.
4. You can cycle forwards or backwards.

Display functions

The display comprises of a two-line screen with
various modes. The top line shows the speed
(km/h) and by pressing the button, the bottom
line can display the following functions:
• Time: This mode displays the duration of your
current training session in minutes and se-
conds.
• ODO: This mode displays the total distance
(km) since the battery was inserted.
• RPM: This mode displays the revolutions per
minute of the pedals.
• DISTANCE: This mode displays the distance
covered in kilometres since the beginning of
the exercise.
• CAL: This mode displays the calories burned
during your current training session.
• SCAN: This mode shows the various display
modes in turn.
Note: The number of calories burned is only an
approximate value.
Note: The display will switch off automatically
after approximately 4 minutes when not in use.

Setting values to zero

Press the button for approximately 4 seconds in
order to set the value back to 0.

Troubleshooting

Error

Display does not show measurement despite
pedal movement.

Possible causes

The sensor is not placed correctly in the sensor
mount.
30 GB

Solution

Check that the sensor is positioned correctly if
the display does not show anything even though
the pedals are moving (figure H).
1. Open the display and remove it carefully, as if
to replace the battery.
2. Insert the sensor carefully into the sensor
mount if it is not positioned correctly inside the
sensor mount.
3. Insert the display back in the article and
ensure that the button on the display is facing
downwards.

Cleaning and care

Clean the article with a damp cloth and a mild
cleaning agent.
Caution! Do not allow moisture to penetrate
the display. Fold the legs away as described in
the section 'folding the article'. Store the article
in a dry place.
Parts that are susceptible to wear: if the article is
no longer offering any step resistance then the
drive belt is worn. The article must be replaced.

Information on disposal

Please dispose of packaging and product in an
environmentally friendly way and according to
the material type!
Dispose of the product through an authorised
waste disposal company or your municipal
authorities. Please observe the currently
applicable regulations.

Disposing of batteries

Batteries must not be disposed of along
with normal domestic waste!
Return batteries to recycling facilities or
the dealer who sold them.
Batteries are marked with a dustbin with
a red cross through it and chemical pollutant
symbols „Cd" for cadmium, „Hg" for mercury
and „Pb" for lead.