Overheating Protection; Commissioning - CASO DESIGN AF 250 Mode D'emploi

14.3

Overheating protection

The device has an overheating protection. In case of too high temperature inside the
device close to electronic components the device will switch off automatically. Pull the plug
and let the device cool down at leat for half an hour.
14.4

Commissioning

1. Connect the main plug into a socket. The device beeps and
display.
2. Unlock & Temperature setting: Press
The display shows „200°C" and „10 Min".Press
increase/decrease the temperature (in 5°C steps) Max.: 200°C, Min.: 60°C.
3. Time setting: Press
(in 1 Min. steps). Max.: 60 Min., Min. 1 Min. Start the device with
4. Let the device preheat for 3-4 Min. without food or add 3-4 Min. to your cooking time.
5. Pull out the frying basket with the handle and fill it with your desired food.
Please note
► Never fill the basket exceed the amount indicated in the table, as this could affect the
quality of the end result.
6. Slide the pot back into the fryer.
WARNING
► Never use the pot without the basket in it.
7. Fast cooking: Press
200°C, cooking time: 10 Min.). While frying you can still adjust the time and temperature
(see above).
8. Auto menus: Press
choose a programme.
Symbol Function
Pre-heat*
Re-heat**
and then
and the device immediately starts frying (Temperature:
, the indicator is shown above
Temp ℃
Time (min)
200 3
180 5
to unlock the device.
and then
or to to increase/decrease the time
. Press
Remark
Preheat the device when it is cold.
To reheat the food when it is cool, adjust
the time if needed.
is flashing in the
or to
.
again to
38