Additional Warnings; Part List - NORAUTO 2274435-NO0538-AB810 Mode D'emploi

3. DO NOT place any objects between the child restraint and the side air bag, as an
expanding air bag may cause the items to strike the child.

ADDITIONAL WARNINGS

1. In hot or sunny weather, ALWAYS check the seat for hot areas before placing a child
into the child restraint. The child could be burned. Cover the child restraint with a light
coloured blanket when you leave the vehicle.
2. This child restraint must be securely fastened to the vehicle, even when unoccupied,
using the vehicle seat belts.
3. An unsecured child restraint may injure someone if a crash occurs.
4. DO NOT attach any additional items, like padding, toys, etc., to this child restraint.
5. Before each use, always confirm child restraint is securely installed and the harness is
properly adjusted around the child.
6. Always confirm before each use that child restraint is securely locked.
7. If the vehicle seat has an adjustable seat-back angle, make sure the seat-back is
securely locked open in its most upright position. An incorrect seat-back angle or
unsecured seat-back will impair the restraint installation and its ability to protect the
child occupant.
8. DO NOT use this child restraint if the child's ears are above the back of the child
restraint headrest.
9. NEVER try to tend to a crying child's needs while driving. Never take a child out of the
child restraint for comforting while the vehicle is moving.
10. DO NOT allow a child to have objects such as lollipops or ice cream on a stick. These
objects can injure the child if the vehicle swerves or hits a bump.
11. Put sharp or heavy items in the trunk. Anything loose can be deadly in a crash.
12. In cold weather a child may need an extra blanket for warmth. Put the child in the child
restraint and cover both the belted child and the child restraint with a blanket.

PART LIST

1. Headrest cover
2.
Belt guidance 1
3. Backrest
4. Seat cover
5. Base
6. Headrest
7. Belt guidance 2
ASSEMBLING, DISASSEMBLING, ATTACHING SEAT COVER
1. By pushing the backrest down, lower the child restraint into a flat position, as shown in
the pictures below.
2. When unfolded, the hook at the bottom of
the backrest can be easily lifted out of the
sockets on the rear of the booster seat.
Pull the seat and the backrest apart. Once
the backrest is separated, store it with the
headrest in safe place, dry place.
3. Set headrest in the highest position. Place
seat cover over the seat bottom, headrest
and the backrest. Then, place the seat cover into splints.
4. Pull the elastic band downwards.
1
6
2
7
3
4
5
EN
35