Starting A Cycle Wash; Changing The Program Mid-Cycle - Pando Integral Cooking PLI-7360 Manuel D'installation Et D'utilisation

Starting A Cycle Wash

1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page"Product fiche".
Make sure that the water supply is turned on to full pressure.
4. Open the door, Press the power button.
5. Press the Program " " button or " " button to choose a program, the response
light will turn on. Then close the door, the dishwasher will start its cycle.

Changing The Program Mid-cycle

A wash cycle can only be changed if it has been running for a short time otherwise, the
detergent may have already been released and the dishwasher may have already
drained the wash water. If this is the case, the dishwasher needs to be reset and the
detergent dispenser must be refilled. To reset the dishwasher, follow the instructions
below:
1. Press the Start/Pause button to pause the washing.
2. Press program button for more than 3 seconds - the program will cancel.
4. Press the program button to select the desired program.
5. Press the Start/Pause button, the dishwasher will
3 sec
164
continued to run after 10 seconds.