Important Safety Instructions; Safety Codes And Standards; Electric Safety - Gaggenau CX482610 Notice De Montage

9 IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
I MPORTANT: The appliance must be
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
installed by a qualified installer.
INSTALLER: leave these instructions with
this unit for the owner. Show the owner
the location of the circuit breaker or fuse.
Mark it for easy reference.
OWNER: Please retain these instructions
for future reference.
9
WARNING
If the information in this manual is
not followed exactly, fire or shock
may result causing property damage
or personal injury.
9
WARNING
Do not repair, replace or remove any
part of the appliance unless
specifically recommended in the
manuals. Improper installation,
service or maintenance can cause
injury or property damage. Refer to
this manual for guidance. All other
servicing should be done by an
authorized servicer.
Remove all tape and packaging before
using the appliance. Destroy the
packaging after unpacking the appliance.
Never allow children to play with
packaging material.
Hidden surfaces may have sharp edges.
Use caution when reaching behind or
under appliance.
This appliance is intended for use up to a
maximum height of 13,100 feet
(4,000 meters) above sea level.
Improper installation is not covered by
the warranty.

Safety Codes and Standards

This appliance complies with one or more
of the following Standards:
UL 858, The Standard for the Safety of
▯
Household Electric Ranges
UL 507, The Standard for the Safety of
▯
Electric Fans
CAN/CSA-C22.2 No. 113-M1984 Fans and
▯
Ventilators
CAN/CSA-C22.2 No. 61-M89 Household
▯
Cooking Ranges
It is the responsibility of the owner and
the installer to determine if additional
requirements and/or standards apply to
specific installations.

Electric Safety

9
WARNING
Before you plug in an electrical cord
or turn on power supply, make sure
all controls are in the OFF position.
If required by the National Electrical
Code (or Canadian Electrical Code), this
appliance must be installed on a separate
branch circuit.
The circuit breaker should have a contact
separation of at least 3 mm on all poles.
3