Salda SA-Control Mode D'emploi page 3

Origine: salda.lt/en
Masquer les pouces Voir aussi pour SA-Control:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
CONNECTING SA-CONTROL REMOTE CONTROLLER TO AN
AIR HANDLING UNIT
Use the following steps to connect a SA-Control remote controller to an air handling unit:
• Unpack the SA-Control remote controller;
• Connect the cable to the connector slot on the control panel pic. 3.1 - 3.3 (page 56):
• Use the cable with an RJ10 connector for the connection to the air handling unit
with PRV control board (further RJ10 cable) pic. 4.1 (page 56);
• Use the cable with an RJ45 connector for the connection to the air handling unit
with a MCB or mini MCB control board (further RJ45 cable) pic. 4.2 (page 56).
• Plug in the RJ45 cable connector to the X18 MCB pic. 5 (page 56) or X18 miniMCB
pic. 6 (page 57) connection slot on the control board. Make sure that the unit is swit-
ched off during the operation. If the ventilation unit is equipped with a PRV control
board, plug the RJ10 cable connector into the RS485_2 slot on the equipment casing,
pic 7 (page 57);
• Plug the ventilation unit into the electric circuit.
SA-CONTROL INSTALLATION ON A WALL
• Turn the panel fig. 2.1 (page 56).
• Put it at the desired location on the wall pic. 8 - 11 (page 57). Mark the positions of
the mounting holes.
• Drill two 5 mm holes at the marked positions for the nylon plugs and the hole
throughout the wall to install the cable pic. 9 (page 57). Insert the nylon plugs. NOTE:
You can use special metal plugs (included) instead of the nylon ones.
• Use the included 2.9x16 DIN7981C screws and mount the panel to the wall as indi-
cated in fig. 8 (page 57).
• Put the panel on the mounting bracket fig. 9 - 11 (page 57).
IMPORTANT: IT IS FORBIDDEN to leave the remaining remote controller's cable
in the AHU's control box pic. 12 (page 57)!
IMPORTANT: Do not forget to connect the cable before attaching the panel.
THE MAIN SCREEN PRV BOARD
PRV
In pic. 13 (page 58) the main window of the PRV board functions is shown:
l1. Date and time.
l2. Temperature of the extracted air (room temperature).
B1. Menu button.
B2. Click to open the fans speed setting window.
B3. Click to open the temperature setting window.
B4. Click to open the mode setting window.
B5. Show the next set of indication panels.
EN
3

Publicité

Table des Matières
loading

Table des Matières