Photo Mode; Playback Mode; Menu Settings - GUARDO DDC-200 Mode D'emploi

PHOTO MODE

A photo icon is shown in the upper left corner of the display.
• Press the button 1x if you want to make pictures instead of recordings.
• Press the
button every time you want to take a picture.

PLAYBACK MODE

A playback icon is shown in the upper left corner of the display.
• For Playback mode, press the
• Use the & buttons to scroll through the recordings.
• Press
to start playback.
• Press the button to pause or begin playback again.
MASS STORAGE MODE
• You can connect the GUARDO DUAL DASHCAM to your PC by using the supplied USB cable. You
can also use it to backup or playback files/videos on your PC.
• Press the
&
computer interface between a computer and a digital camera which shows the digital camera as
a removable disk drive attached to the computer.
You don't need to install drivers to use the HD DASHCAM with your PC because these are already
installed by Windows/Macintosh in the Windows/Macintosh pack.
You should connect the HD DASHCAM as following :
1. Make sure the battery is charged.
2. Only use the SUPPLIED USB cable.
3. Turn the DASHCAM ON.
4. Connect the USB cable with the DASHCAM before connecting it to the PC.
5. Select "MASS STORAGE" on the DASHCAM and press the
6. The driver will now install itself and in the folder "My computer" on your desktop you will see a
new (hard)disk (it is possible that a window will appear in which you can indicate how you would
like to view the files).
7. You can now see all files in the folder and double-click them to watch the videos using the
standard Windows Media Player or Apple Quicktime (you can select yourself).
Note:
You can also remove the micro SD card from the DASHCAM and place it in a (built-in or optional)
micro SD card reader from your PC or a separate micro SD card reader if you have one. This is a
quicker and easy-to-use solution.
B. MENU SETTINGS
Attention: This menu will not work if Mass Storage mode is activated.
1. Power on the unit with the supplied car charger or by using a fully charged battery.
2.
Stop the recording if needed.
3. Press until you have selected the desired mode
4.
Press to enter the menu#.
5. Press &
6.
After selection, click
7.
Press to exit the menu.
button 2x.
buttons to choose the mode and then press
buttons to scroll through the submenu's.
to confirm and save the setting.
: Mass storage (USB mode) is a
button.
.
#
-8-