G-SENSOR ACCIDENT FUNCTION
When gravity acceleration reaches up to 8G (1G = 9.8m/s), the camera will automatically store the
video and protect it against being auto-deleted. You can change this setting manually if desired.
PARKING MODE & SOS FUNCTION
In idle mode (when not recording), press and hold the
on the right side of the display. When the car is parked and it is hit or shaken (in case of a parking
accident), the camera will start recording for 30 sec. Afterwards, the camera will turn off and return
to parking standby mode. Press
recorded. On the micro-SD card, this file will be tagged as a locked file.
CHARGING
• The device has a small built-in Li-ion rechargeable battery for emergency use that has to be fully
charged and discharged 4 times on battery function to activate the maximum capacity of the
battery. Charging time is about 2 hours maximum.
• The status of the battery is indicated by following symbols:
0%
25%
• The red indication light turns on while charging and turns off once the battery has been fully charged.
• The camera records for max. 15 minutes when not connected to any power source (depends on
settings/mode).
Charging options:
• Connect the device to a computer/laptop using the USB connection cable. OR
• Plug the device into the included cable + car charger for use in car or truck. As soon as the car
engine turns on, the device will start recording. The GUARDO DUAL DASHCAM will now also be
charged while recording. When the car charger is disconnected from the unit, the GUARDO DUAL
DASHCAM will shut down automatically and save the files.
Caution:
• With low battery, the GUARDO DUAL DASHCAM will enter a protection mode. Please charge the
battery to ensure you can turn on the device and continue to use it.
• GUARDO DUAL DASHCAM can only be used with the supplied 5V (12/24V) car power supply. Any
other power supply may cause errors and/or permanent damage to the device.
USING MICRO SD CARD (TF)
shortly to immediately save and lock the video while it's being
70%
100%
(not included, optionally available)
button, a camera symbol will be shown
-4-