Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
There are 2 ways of connecting the rear camera to the car/truck's electronic system
1. Plug & play connection: via the adapter for the cigarette lighter, 12/24 V systems.
2. (optional) Reverse signal detection: immediately to the car/truck's rear signal light system (12~24
V) via the red + power cable. The red wire should be connected to the + voltage of the car/truck
reverse signal/light power supply. If the reverse signal is connected to the reverse signal light
power, the front and rear camera will switch ON/OFF automatically when you select the reverse
gear from your car's gear box or automatic transmission box. Once the gear is in rear-position, the
camera will switch to rear camera automatically and the LED lights will turn on* .
Note: Connect the red wire with the contact clip. Put the car/truck wire in the groove of the clips and
the cable wire in the groove with the confining rib, and push it hard to connect.
*
Use a tool to lift the edges of the rubber window sealing and molding and push the rear and front
camera connection cables inside.
*
When using the rear camera inside the car, we advise to
add the light cover on top of the LED lights to have no
reflections or disturbances.
Attention!
If there is no "Reverse signal/light" wire or if it is unavailable, you should not connect the red cable
but consult your garage/car manufacturer for more info.
Note: To avoid distortions make sure that the cables are laid far away from the electronic systems
of the car/truck.
OPERATION
A. MODES
Attention: This menu will not work if Mass Storage mode is activated.
VIDEO RECORDING MODE
A camera icon is shown in the upper left corner of the display.
•
When the GUARDO DUAL DASHCAM is connected to your car's power supply, it will start Video
recording as soon as the car engine is started. It will stop recording after the car is stopped.
•
When the GUARDO DUAL DASHCAM is not connected to the car's power supply, press and hold
the
button, and press the
Video recording mode. Press
•
Loop recording: During recording, the device will save each video file every 1, 5 or 10 minutes
automatically. When the micro SD card is full, the device will delete the oldest video files
automatically one by one.
Power line
Reverse signal red + wire
button to start recording. The unit will automatically be in
again to stop recording and save the files automatically.
-7-
6m
3.5m
Cigarette plug cable
Publicité
Table des Matières
