GUARDO DDC-200 Mode D'emploi page 5

• Insert your micro SD card into the SD slot until it clicks into place.
• To remove the micro SD Card, press the card lightly. It is partially ejected allowing you to pull the
card out.
• With no card in the SD slot, the display will inform you with an 'Please insert SD card' message.
Note:
• We recommend using a 16GB SDHC micro card (or higher, max. 64 GB SDHC) with class 10, 15
MB/s writing (or higher).
• Without SD card, the device will NOT work!
• If the micro SD card is inserted in a wrong way (difficult to insert), it may damage the device and
the memory card.
• The device will automatically set up the micro SD-card after it's been inserted.
VIDEO*
MICRO SD CARD 1920xFHD1080P
32 GB 225 min
16 GB 112 min
MOUNTING
FRONT CAMERA
• Slide the GUARDO DUAL DASHCAM into the
mounting bracket.
• Clean the window with alcohol / window
cleaner and dry it. Take off the protection
strip from the holder and place it firmly
on the inside of your windshield (push &
hold) and close the holder using the lever.
We recommend placing the dashcam on the
right side of the rear view mirror.
• Adjust the bracket by using the adjustment
knob.
• Make sure the camera is mounted horizontal
for the best view.
• Connect the car charger to the car lighter for
power.
REAR CAMERA
• Turn the power of the car OFF when connecting the camera.
• Clean and dry the desired location before installation.
• Ensure that the cable is placed so that it will not be damaged (e.g. not laid under car/truck seats
or over sharp edges beneath the dashboard).
The rear camera HDMI cable is used for plug & play installation. It provides power supply & video
via the cigarette lighter from the front camera. The HDMI cable comes out of the front camera
screen unit and is used for connecting the front camera screen unit to the rear camera via the
socket.
IMAGE (examples) *
1280x720P 4032x3024 2MP
252 min 12624
126 min 6312
-5-
2592x1944 5MP 2048x1536 3MP
31600 48316
15080 24158