Step 3 - Install The Receiver - DigiSender Plug'n'Go LCD Série Mode D'emploi

ENGLISH (UK)
DX2000-LCD - DigiSender® Plug'n'Go™ LCD - Single Input 5.8GHz Wireless AV Sender System
Installing your DigiSender®

Step 3 - Install the Receiver

The Receiver will pick up the signals being sent by your Transmitter and output them to a connected
TV.
1.
Locate a vacant SCART socket on the back of your
receiving TV and insert the DigiSender® SCART
cable.
3.
Position the IR Sensor on the top, side or bottom
of your receiving TV using the supplied sticky pad.
Ensure that the lens of the IR Sensor is facing out
into the room, approximately pointed towards
where you will be using the remote control from.
Page 06
2.
Connect the Receiver to a mains socket. Again,
you might want to consider plugging the Receiver
into a mains extension lead.
4.
Press the power button to turn the Receiver on.
Pressing the power again will cycle through the
4 available A/V channels. Make sure it is set to
Channel 1 for the moment.
Please read the instructions carefully prior to installation