Step 2 - Install The Transmitter - DigiSender Plug'n'Go LCD Série Mode D'emploi

DX2000-LCD - DigiSender® Plug'n'Go™ LCD - Single Input 5.8GHz Wireless AV Sender System
Installing your DigiSender®

Step 2 - Install the Transmitter

The Transmitter will send the audio and video from a connected source (your Satellite receiver for
example) to the Receiver, located in another room in your home.
1. 4.
Connect the DigiConnector™ to your Satellite,
Obis aut et pe nisin pre nonectius ipis ipicit eum
Cable or Freeview box. Use the SCART socket la-
dem nos net etur modipissi alit in eumet ipsunto te
belled 'TV' or 'OUT'. Connect any existing SCART
nobitatur sunt, et, sandae ratur sincimus.
lead into the rear of the DigiConnector™.
4. 3.
Position the IR Emitter in front of your source de- Obis aut et pe nisin pre nonectius ipis ipicit eum
vice (satellite, cable, freeview, DVD, etc.) with the dem nos net etur modipissi alit in eumet ipsunto te
lens facing the equipments IR Sensor. nobitatur sunt, et, sandae ratur sincimus.
Please read the instructions carefully prior to installation
2.
Connect the Transmitter to a mains socket. You
might want to consider plugging the Transmitter
into a mains extension lead, as being able to move
the unit around will help in getting the very best
picture.
4.
Press the power button to turn the Transmitter on.
Pressing the power again will cycle through the
four available A/V channels. Make sure it is set to
Channel 1 for the moment.
ENGLISH (UK)
Page 05