Klarstein ARIANA Mode D'emploi page 29

5. Place the inner chimney on the inner chimney holder. Mount the outer chimney
bracket to the outer chimney using two screws (4 x 8 mm). Drill holes in the wall to
fix the outer chimney bracket.
Note: Remember not to overtighten the screws (4 x 8 mm). We recommend that you
tighten them loosely so that the height can be easily adjusted later.
6. Drill 2 holes for the inner chimney holder. Fix the inner chimney mount to the wall
using the supplied screws (4 x 40 mm) and dowels.
Note: The inner chimney bracket is used to fasten the chimney. The following
illustration only serves as a reference. The chimney is attached to the wall plate at the
end of the installation.
Drill 2 holes for the outer chimney holder.
EN
29