Klarstein ARIANA Mode D'emploi page 27

Installation (Vent outside)
Note: When the range hood and appliance supplied with energy other than
electricity are simultaneously in operation, the negative pressure in the room must be
not exceed 4 Pa (4 x 10-5 Bar).
Installation (Vent inside)
If you do not have an outlet to the outside, exhaust pipe is not required and the
installation is similar to the installation (vent outside).
Installation
CAUTION
Risk of electric shock! Only use the supplied screws and fi xing devices
to install the extractor hood and follow the instructions in this manual.
Failure to do so may increase the risk of electric shock.
1. Fix two 4 x 30 mm screws to the wall with dowels. Place the hood body on the two
screws.
EN
27