Preparation - Panasonic ER‑SB60 Mode D'emploi

Preparation

Charging
• Turn the appliance off.
• Wipe off any water droplets on the appliance socket and the
charging stand.
1
Connect the appliance plug to the
appliance socket.
2
Plug in the adaptor into a
household outlet.
• Check that the charge status lamp (
glows.
• Charging is completed after approx.
1 hour.
3
Disconnect the adaptor after charging is completed.
While charging
The charge status lamp (
glows.
The battery capacity lamp will
blink in order of "LOW", "MID",
and "HIGH" while the charging
progresses.
ER-SB60_40_EU.indb 11
)
1
After charging is completed
) The battery capacity lamp and
the charge status lamp (
will light up and then turn off
after 5 seconds.
Notes
• If there is noise from the radio or other sources while using or
charging the appliance, move to a different location to use the
appliance.
• The battery will deteriorate if not used for over 6 months, so
make sure to perform a full charge at least once every 6 months.
• The charging time may differ when using the appliance for the
first time, or if it has not been used for more than 6 months. The
lamp on the appliance may not glow for several minutes when
first starting charging, but will glow when continuing to charge.
• Recommended ambient temperature for charging is
10 °C – 35 °C. It may take longer to charge, or the charge status
2 lamp ( ) will blink quickly and the battery may fail to charge
properly in extremely high or low temperatures.
• When the charge status lamp (
second), there is a charging malfunction. Please charge the
battery in the recommended ambient temperature range.
• 1 full charge will provide approximately 60 minutes of continuous
operation. (Based on dry using at 20 °C – 30 °C)
The operating time may differ depending on the frequency of use
and the operating method.
• The battery used is a lithium‑ion, so charging after every use will
have no effect on battery life.
Charging with the charging stand
ER-SB60
1. Insert the appliance plug into the charging
stand.
)
2. Place the main body on the charging stand.
3. Plug in the adaptor into a household outlet.
) is blinking rapidly (twice every
3
2
1
11
2017/05/25 11:00:21