Rowenta FOCUS DZ5030G1 Mode D'emploi page 37

1103902631 DZ5000 F1
Move the steam control to
Plug in the iron and allow the iron to heat up again. Wait until the
remaining water has evaporated. Unplug from the mains and allow
the iron to fully cool down.
When cool, the soleplate can be wiped with a damp cloth.
TIP Use the Self Clean function approx. every 2 weeks.
If the water is very hard, clean the iron weekly.
17 • Cleaning the iron
When the appliance has cooled down, wipe it down with a damp
cloth or sponge, as required.
Remove the dirt from the soleplate with a damp cloth or sponge.
IMPORTANT Do not use sharp or abrasive cleaning agents or
objects to clean soleplate and other parts of the iron.
If the appliance has been standing unused for long periods,
use the Self Clean function (see § 16).
PROBLEMS?
Problems Cause
The iron is
plugged in, but
the soleplate of
the iron
remains cold.
Thermostat
control light* or
the yellow led*
goes on and
off.
* depending on model
27/11/07
position after approx. 1 minute.
No mains supply.
Temperature control
set too low.
The automatic
electronic cut-out* is
active.
This is normal.
31
10:36 Page 31
Solution
Check that the mains plug is properly
inserted or try plugging the iron into
a different socket.
Set the temperature control to a
higher temperature.
Move your iron.
When the thermostat control light* or
the yellow led* goes on and off the
iron is heating up. As soon as the
thermostat control light* goes off or
the green led* lights up the set
temperature has been reached.