ShelterLogic 23532 Mode D'emploi page 5

5. plAce cover AnD secUre to cAnopY FrAMe
A. Place cover over assembled roof frame with grommet panels facing down, aligned with cross rails.
B. Make sure the cover is properly aligned on the frame, secure the four corners of the cover with bungees
to the frame first
(10066)
Re-adjust bungees position along cross pole as needed to ensure a tight and even fit of the cover to the frame.
Grommet Panels for Bungees
10066
Grommet
Panel
6. tiGHten tHe cover WitH tWist tite
A. Wrap the cord with plastic ball and "S" hook at the corners of the cover around the
corner leg poles. Insert "S" hook into the hole of the corner leg poles.
B. Twist each leg pole toward the inside of the shelter until the cover becomes tight
Twist the leg poles equally to ensure the cover stays aligned during tightening.
Attach remaining bungees.
.
Insert Bungee Cord Through Grommet
™
Page 5
Leg Pole to Side Frame Connections
13102
13105
Secure Bungee Around Plastic Ball
Twist-Tite Tighten Cover
™
13101
13105
05_23532_29532_0F