Fitting
Instructions
MATERIALS
A
1
Cross Bar with European facing to 94/20/EC A50-1.
B
4
M8 x 40 x 1.25 mm Bolts (10.9), 4 Lock washers, and 4 Flat washers (25 mm O.D.)
C
2
M8 x 1.25 nut, 2 Lock washers, and 2 Flat washers (20 mm O.D.)
D
1
Left side arm
E
1
Right side arm
F
4
M12 x 35 x 1.75 mm Bolts, Nyloc Nuts, 4 Flat Washers (25 mm O.D.) & 4 Bolt caps.
G
1
ZEP 35 Electrical Plate (not shown)
CB
2
M16 x 40 x 2.0 mm Coupling Bolts, Nuts and Lock Washers.
FITTING
On the underside of vehicle remove two bolts from bumper tags and fold downwards. Remove 3 lower arch plugs each
1.
side and lower plastic cowling downward to expose crash beam ends.
On each side of crash beam remove 2 lower bolts each side, to access the rear mounting points.
2.
Lower the rear silencer by removing the 4 nuts from the two exhaust hangers and rest on the rear suspension.
3.
Fit crossbar (A) inside of bumper and bolt to rear of crash beam using fixings (B). Raise face plate as high as possible
4.
whilst tightening. This can be easier if two people are present.
Before fitting side arms make a small cut on right side bumper tag as shown. Fit side arms (D) and (E) to vehicle
5.
chassis studs using fasteners (C) and use fasteners (F) to bolt arms to cross bar. Fit Bolt caps.
Continue tightening all bolts to their recommended torque. Bolt exhaust hanger back in place and refit lower arch fixings.
6.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings:, M8 - 27Nm, M12 - 95 Nm , M16 - 214 Nm. 10.9 Specification M8 – 35Nm
W0001PG47A-FIT$0111031500000Ä
W0001PG47A-FIT$011103150000
TOWBAR
For Peugeot 308 SW PG47A