Configuration; Configuration: General; Configuration: Network - De Dietrich DL2 Manuel

DL2

10. Configuration

10.1 Configuration: General

10.2 Configuration: Network

34
|
In the following sub-windows of the web interface, the set-
tings of the DL2 can be changed.
In order to save the changes, click on „Save changes".
«
The „Print Configuration" button:
In order to print the current configuration of the web
«
interface, click on „Print Configuration".
In the configuration window „General" carry out the following
settings:
Enter username
«
Enter password
«
Repeat password
«
Enter device name (characters permitted: letters,
«
numbers, underline character)
Adjust logging interval (1 ... 86400 s; the smaller the
«
interval, the more capacity is required)
Adjust logging mode
«
Username and password are required for the next access
to the web interface
Note:
If you have forgotten your password, please carry
out the following steps: Copy the data onto an SD
card (see chapter 6) and afterwards reset the DL2
(see chapter 5). The DL2 will then be set back to
the factory settings.
Logging mode
There are two types of logging modes:
• Cyclic
(factory setting):
If the internal memory of the DL2 is full, the oldest data
packets will be overwritten.
• Linear:
If the internal memory of the DL2 is full, no further
data will be logged.
In the configuration window „Network", the settings
mentioned below have to be carried out. When the auto-
configuration is not enabled, all network parameters have
to be entered manually into the fields below.
Enable / disable the LAN auto configuration
«
Information such as IP address, IP netmask, etc. is indicated.
«