Installation; Mounting; Connection - De Dietrich DL2 Manuel

DL2
2.

Installation

2.1 Mounting

2.2 Connection

7
Router
6
8
LEDs
SD card
terminals
interior view
28
|
(1)
4
1
2
3
LAN socket
WARNING!
Always disconnect the device from
power supply before opening the
housing!
The unit must only be located in dry interior locations. It is
not suitable for installation in hazardous locations and should
not be placed close to any electromagnetic fields.
Please pay attention to separate routing of sensor cables and
mains cables in order to avoid interferences.
Choose a mounting place
«
Drill two holes (Ø 6mm) next to each other at a di-
«
stance of 113 mm and insert the enclosed wall plugs.
Attach the base by means of the enclosed screws
«
(4 x 40 mm) (1).
Connect the datalogger (pos.1) to other modules in
the following order:
Connect the data cable (VBus
«
ler (pos.4). Extend, if necessary, with en closed screw
terminal and (twisted) two-wire cable.
Plug mains adapter (Pos.2) into the mains socket.
«
For direct connection of a router or PC, connect the
«
datalogger to the router (pos. 7) or PC (pos. 8) by
means of the network cable (enclosed, pos.6).
The power supply to the device must be carried out via an
external mains adapter and the supply voltage must be
100 ... 240 V~ (50 ... 60 Hz).
The DL2 is supplied with connected mains adapter and
VBus ® -cable.
VBus ® connection at terminals:
1 / 2 = VBus - connection 1
®
3 / 4 = VBus - connection 2
®
, pos.3) to the control-
®