Philips SC2001/00 Mode D'emploi page 17

4 Press the % button to increase the intensity. To lower the intensity,
press the ^button.
Every time you press the button, the corresponding intensity
,
light starts to flash. This takes a few seconds.
5 Place the appliance in a 90° angle on the skin so that the attachment
and the safety ring are in contact with the skin.
6 Press the safety ring fully onto the skin with slight pressure.
Note: The safety ring has contact switches that together are the safety system
of the appliance. This safety ring prevents unintentional flashing without skin
contact.
, The 'ready to flash' light on the back of the appliance lights up green
when all contact switches of the safety ring are in contact with the
skin and the appliance is charged. This may take up to 3.5 seconds.
Tip: For easier use, stretch the area of skin you want to treat. On areas with
softer skin, you may need to exert more pressure on the appliance to push in
all contact switches.
7 Press the flash button to release a flash.
Note: The visible light produced by the appliance is the reflection of the flash
on the skin and is harmless to your eyes. It is not necessary to wear goggles
during use.
8 Let go of the flash button after the appliance has flashed.
9 For the next flash, repeat steps 6 to 9. After each flash it takes up to
3.5 seconds until the appliance is ready to flash again.
Do not treat exactly the same area multiple times during one session.
This does not improve the effectiveness of the treatment, but increases
the risk of skin reactions.
EngliSh
17