General Guidelines - Velleman XMPL11 Mode D'emploi

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Protect this device from shocks and abuse. Avoid brute force when operating the device.

Familiarise yourself with the functions of the device before actually using it.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Keep this manual for future reference.
4. Installation
For outdoor use, do not install the chain or replace lamps during rain or other inclement
weather conditions.
Inspecting the Chain Before Installation
1. Take the chain out of the box and unroll it fully.
2. Make sure that the power plug is disconnected from the power supply.
3. Check the plug, cable, insulation, lamp holders, and lamps for damage:
Replace any damaged lamps. See Fitting or Replacing Lamps for detailed instructions.
o
If you notice any other damage, do not use the chain and contact your dealer.
o
Testing
Test the chain before installing it.
1. Plug the chain into a suitable power socket.
2. Check if all lamps are working.
If yes, you can proceed with the installation.
o
If no, disconnect the chain from power and contact your dealer.
o
Installation
To install the chain after testing, proceed as follows:
1. Choose a suitable mounting spot. Make sure that the chain cannot get damaged, for example by
sharp edges, swinging windows, doors, etc. Also, make sure that the chain cannot cause hazardous
situations if it accidentally comes loose. For example, avoid crossing passageways. Not suitable for
installation in cabinets, ceilings, or other enclosures. Not suitable for installation under water.
2. To mount the chain, start at the side of the power plug. Position the power plug near a mains outlet,
but do not plug it in yet. Make sure to leave enough power cable to easily plug into the mains
outlet without stress on the cable.
3. Start mounting the chain in the desired location.
Caution: make sure not to damage the insulation during installation. Do not use sharp tools to
install the chain. Do not fix the chain to buildings or other supports using nails, staples, or
other sharp, conducting materials.
4. It is recommended to fix the chain to a support at least every metre.
5. Operation
1. Plug the chain into a suitable mains outlet to switch it on.
2. Unplug it from the mains to switch off.
V. 01 – 20/09/2016
XMPL11
4 ©Velleman nv