Operating Modes - Danby DPA100B6WDB Manuel Du Propriétaire

OPERATING INSTRUCTIONS
CONTROL PANEL
1. Swing button: Press to start the auto swing
feature. When auto swing is activated, press
again to stop the louver at the desired angle.
2. Sleep and fi lter button:
• Press to start the sleep feature.
• The fi lter light will illuminate after 250 hours of
use as a reminder to clean the fi lter; to reset the
fi lter after cleaning, press and hold the sleep
button for three seconds.
3. Timer button: Press to start the automatic timer.
Light will indicate whether a timer is set.
4. Fan button: Press to select fan speed; low,
medium, high or auto. Light will indicate current
speed.
5. Mode button: Press to select the desired mode.
Light will indicate current mode.
6. LED display:
• Shows the set temperature in °C or °F.
• Shows the timer settings.
• While on dry and fan mode, shows the room
temperature.
7. Up and down arrows:
• Used to set the temperature.
• Press and hold both up and down buttons for
three seconds to change the temperature display
from °C to °F.
8. Power button: Press to turn the appliance on or
off.
1 2 3 4
3sec
6
8
5
7

Operating Modes

• Cool Mode
Choose cool mode to set the cooling function. Use
the up and down arrows to choose the desired
temperature. When cool mode is selected, the fan
speed can be adjusted by pressing the fan button on
the remote control.
The temperature can be set within a range of 17 -
30°C (62 - 86°F).
The exhaust hose should be installed during cool
mode to ensure the best results.
• Dry Mode
Choose dry mode to remove excess moisture
from the air during periods of high humidity. All
water pulled from the air will condense inside the
appliance and drain out the back.
The humidity level and fan speed will be
automatically set and cannot be modifi ed in dry
mode.
• Fan Mode
Choose fan mode to run the internal fan without
engaging the cooling function. Press the fan button
on the remote control repeatedly to choose the fan
speed: low, medium, high or auto.
• Auto Mode
Auto mode is a pre-set factory program that
automatically defi nes the mode (cool or fan) and
fan speed based on the set temperature and the
ambient temperature.
7