Package Contents; Unpacking & Assembly 7 - AR Blue Clean AR 383 Manuel Du Propriétaire

Fig. 1 Fig. 2
Fig. 3
Pump
High Pressure Hose
Fig. 4 Fig. 5
U
nPacking
Detergent
Bottle
• After unpacking the BLUE CLEAN POWER WASHER, lay
out parts and accessories. Familiarize yourself with the parts
in the package by comparing them to those listed on the
"PACKAGE CONTENTS" page.
• The BLUE CLEAN POWER WASHER requires some minor
assembly. You'll need a Phillips screwdriver to install the
accessory holders .
• Install the accessory holder on the back of your BLUE
CLEAN POWER WASHER (Fig. 1). You'll notice where the
accessory holder meets the back of the unit. You will see
GHA
several male index posts which fit into female holes. The
posts and holes enable easy placement of the accessory
holder and easy tightening of the screws. Place the screws
in the holes provided on the accessory holder and screw
them in. Do not use a power screwdriver. When the screw
is completely tight, give a small final clockwise twist of the
screwdriver. Do not over tighten. After the accessory holder
is installed you will notice a square area in the center of the
holder where the square detergent bottle may be stored and
easily retrieved (Fig. 2).
• Using one of the supplied screws, install the small electric
power cord holder below the accessory holder so that the
"L" - shaped holder faces downward. The electric power cord
can now be wrapped around the accessory holder and the
bottom "L" - shaped holder while your power washer is not in
use (Fig. 1).
• Please refer to (Fig. 3) for accessory storage locations on
the accessory holder.
High Pressure Hose
• Screw the high pressure hose (clockwise) on the back of
the unit at the bottom (Fig. 4). The end of the hose must be
inserted into the water outlet far enough so the collar can
thread onto the outlet threads until hand tight. Do not use
pliers or vice grips to tighten. If it takes fewer than six or so
turns you have not properly tightened the high pressure hose
fitting. It is easier to position the power washer in front of you
so to ensure that the threads are started correctly. Failure to
properly tighten the high pressure hose will result in the hose
slipping or popping off immediately upon turning the unit on.
Do not worry about damage if this occurs - just reinstall and
take extra care at screwing on the high pressure hose fitting.
• Connect the other end of the high pressure hose to the spray
gun by inserting the brass metal tip of the high pressure hose
into the fitting just ahead of the trigger guard. It will lock into
& a
ssembly
En - 7